Model 98 Cast Iron Series
* Non-clogging engineered plastic vortex impeller design.
* Corrosion resistant powder coated epoxy finish.
* Durable cast construction. Cast switch case, motor, pump housing and base. No sheet metal parts to rust or corrode.
* Castings - All cast iron class 25-30 25000# tensile strength.
* Stainless steel screws, guard, handle, arm and seal assembly.
* Float operated submersible (NEMA 6) 2-pole mechanical switch.
* Motor - Permanent split capacitor, 60 Hz, 1725 RPM, oil-filled, hermetically sealed, automatic reset thermal overload protection.
* Bearings - Upper & lower oil fed cast iron.
* Carbon and ceramic shaft seal.
* Entire unit pressure tested after assembly.
* Watertight neoprene “” ring between motor and pump housing.
* Maximum temperature for effluent or dewatering 130°F - 54°C.
* Passes ½ inch spherical solids.
* No screens to clog.
* Standard cord length 15 ft. (UL Listed).
* 1½” NPT Discharge (1½” X 2” PVC Adapter included with BN & BE Models).
* On point - 9½”
* Off point - 3”
* Major width - 10 1/8”
* Height - 12”
The sizing of effluent systems normally requires variable level float(s) controls and properly sized basins to achieve required pumping cycles or dosing timers with nonautomatic pumps.
Specifications:
Material: Cast Iron
Voltage: 115 V
Phase: 1
Mode: Non-Automatic
Current: 9.4 A
Control Selection (Simplex): 2,3
Control Selections (Duplex): 4
On Point: 9 1/2 inches
Off Point: 3 inches
Width: 10 1/8 inches
Height: 12 inches
Related Parts
View Cart
